Q7 Quattro V6-3.6L (BHK) (2007)
NOTE: Remove padding only until Front Passengers Seat Occupied Sensor G128 - 2 - has been freed up.
-
Remove Front Passengers Seat Occupied Sensor G128 connector - 2 -.
-
Carefully remove Front Passengers Seat Occupied Sensor G128 - 2 - from seat padding - 1 -.
Installing
CAUTION: Observe safety precautions for work on airbags precautions.
Installation is reverse of removal. Observe the following when doing so:
-
Position circuit board - 4 - from Front Passengers Seat Occupied Sensor G128 - 2 - in cut-out - 3 - in seat padding - 1 -.
-
Align Front Passengers Seat Occupied Sensor G128 - 2 - on seat padding - 1 - as shown in illustration.
-
Remove protective foil and adhere Front Passengers Seat Occupied Sensor G128 - 2 - to seat padding - 1 -.
NOTE: Ensure Front Passengers Seat Occupied Sensor G128 is not covered by seat heater element heating coils.