Q7 Quattro V6-3.6L (BHK) (2007)
Fuse Block: Service and Repair
Driver Side E-Box Plenum Chamber
Driver Side E-Box Plenum Chamber
Removing
-
Remove windshield wiper motor. Refer to => [ Windshield Wiper Motor with Wiper Motor Control Module ] See: Wiper and Washer
Systems/Wiper Motor/Service and Repair.
-
Remove screws - arrows - and remove E-Box plenum chamber cover.
-
Disconnect electrical multi-pin connectors - 2, 3, 5, 6, 7, 8, 9 - on E-Box plenum chamber connector station.
-
Remove connector - 10 - from E-box plenum chamber.
-
Remove both wiring harnesses - 1 - and - 4 - from E-box plenum chamber mount.
-
Release catches - 11 - and - 12 - and pull relay carrier - B - in E-box up - electrical wiring remains connected.