Q7 Quattro V6-3.6L (BHK) (2007)
Fuse Block: Service and Repair
Driver Side E-Box Plenum Chamber Fuse and Relay Carrier
Driver Side E-Box Plenum Chamber Fuse and Relay Carrier
Removing
-
Remove windshield wiper arm - 1 - and - 3 -. Refer to => [ Windshield Wiper Arms ] See: Wiper and Washer Systems/Wiper Arm/Adjustments.
-
With ignition switched off, disconnect battery Ground (GND) wire. Refer to => [ Battery Disconnecting and Reconnecting ] See: Battery/Service
and Repair/Removal and Replacement/Battery Disconnecting and Reconnecting.
-
Remove rubber seal - 5 - on plenum chamber cover.
-
Remove plenum chamber cover - 4 -.
CAUTION!
Coat the transition between the windshield and cowl panel trim - 2 - with some soapy water and carefully pull the cowl panel trim vertically
out of the retainer on the windshield beginning at the edge of the window.
-
Carefully remove plenum chamber cover - 2 - from catch on windshield.
-
Remove screws - arrows - and remove E-Box plenum chamber cover.
-
Release catches - arrows - and pull up relay and fuse carrier - 1 - and relay carrier - 2 - and - 3 - in E-box.