Q7 Quattro V6-3.6L (BHK) (2007)
-
Seal both connections. Make sure that no dust particles enter connections.
-
Turn wheel hub far enough until one of the holes for wheel bolts is on top.
-
Install (T10149) with wheel bolt.
-
Insert (T10149) into (V.A.G 1383 A) and press wheel bearing housing far enough upward until control position, dimension - a -, is obtained.
Control position
‹› Dimension - a - for vehicles with air suspension 465 mm
CAUTION!
‹› Do not lift or lower vehicle when the (V.A.G 1383 A) stands below the vehicle.
‹› Do not leave (V.A.G 1383 A) below vehicle any longer than necessary.
Working after adjusting control position
-
Tighten respective bolts/nuts.