Q7 Quattro V8-4.2L (BAR) (2008)
Collision Avoidance Module: Service and Repair
Rear View Camera System Control Module
Rear View Camera System Control Module
The Rear View Camera System Control Module J772 is located behind right luggage compartment side trim.
-
If control module is replaced, select the function "Replace" of respective control module in "Guided Fault Finding".
Use Vehicle Diagnosis, Testing and Information System VAS 5051A to do so.
-
Switch off all electrical consumers.
-
Remove ignition key.
Removing
-
Remove right luggage compartment side trim.
-
Remove nuts - 1 - and - 5 - (4 Nm).
-
Disconnect harness connectors - 3 - and - 4 -.
-
Remove Rear View Camera System Control Module J772 - 2 -.
Retaining Bracket, Removing
Two retaining brackets are bolted to the Rear View Camera System Control Module J772.
-
Unscrew bolts - 5 - (2 Nm) and remove retaining bracket - 1 -.
-
Unscrew bolts - 4 - (2 Nm) and remove retaining bracket - 3 -.
Installing
-
Install retaining brackets first.
-
Installation of the Rear View Camera System Control Module J772 is the reverse of removal.
-
Perform calibration