Q7 Quattro V8-4.2L (BAR) (2008)
Air Bag Control Module: Service and Repair
Airbag Control Module
Removing
CAUTION: Observe safety precautions for work on airbags.
-
Switch off ignition.
-
Disconnect battery ground wire.
-
Remove center console storage compartment.
-
Remove Multimedia Control Head E380.
CAUTION: Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static
electricity". This can be done by touching door striker, for example.
-
Remove nuts - 1 - (Qty. 3) from threaded pins.
-
Remove Airbag Control Module J234 - 2 - from threaded pins.
-
Open securing clip at connector - 3 -.
-
Remove connector - 3 -.
-
Remove control module - 2 - from center console.
Installing
CAUTION:
-
Observe safety precautions for work on airbags
-
Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This can
be done by touching door striker, for example.