Q7 Quattro V8-4.2L (BAR) (2008)
Windshield Washer Control Module: Service and Repair
Windshield Wiper Motor with Wiper Motor Control Module
Special tools, testers and auxiliary items required
‹› Assembly tool (T10118)
Removing
-
Remove windshield wiper arm - 1 - and - 3 -. Refer to => [ Windshield Wiper Arms ] See: Wiper and Washer Systems/Wiper Arm/Service and
Repair.
-
Remove rubber seal - 5 - and remove plenum chamber cover - 4 -.
CAUTION!
Coat the transition between the windshield and cowl panel trim - 2 - with some soapy water and carefully pull the cowl panel trim vertically
out of the retainer on the windshield beginning at the edge of the window.
-
Carefully remove plenum chamber cover - 2 - from catch on windshield.
-
Remove engine cover.
-
On vehicles with a 12-cylinder TDI engine, remove the intake flap motor/intake flap motor 2 (V157)/ (V275).
-
Remove screws - arrows -, rotate wiper crank if necessary.