R8 Quattro Coupe V10-5.2L (BUJ) (2010)
-
Carefully turn the Climatronic control module - F - 180°.
-
Release the connectors - A through D - by pressing the retaining tabs - G - and remove them.
Installing
Installation is done is reverse order, observe the following:
-
When replacing the Climatronic control module, pay attention to the exact allocation.
-
Install the center console right side trim.
After finishing the repairs, perform the following work on the Climatronic Control Module (J255) using Vehicle diagnosis, testing and information
system VAS 5051/ in the "Guided Fault Finding" function:
-
Perform the coding or check the code.
-
Perform the basic setting.
-
Check the DTC memory (and correct the cause of any malfunctions that may be shown).
-
Check adaptation.
-
Perform the output diagnostic test mode if necessary.