R8 Quattro Coupe V10-5.2L (BUJ) (2010)
Headlamp Control Module: Service and Repair
Right LED Headlamp Power Output Module 4 and Left LED Headlamp Power Output Module 1
Right LED Headlamp Power Output Module 4 and Left LED Headlamp Power Output Module 1
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] See: Lighting and Horns/Service Precautions.
‹› Headlamps must be adjusted after performing measures that could influence headlamp adjustment. Refer to => [ Headlamps, Checking and
Adjusting ] See: Lighting and Horns/Headlamp/Adjustments.
Removing
-
Remove headlamp. Refer to => [ LED Headlamp Housing ] See: Lighting and Horns/Headlamp/Service and Repair/Removal and
Replacement/LED Headlamp Housing.
-
Remove screws - arrows -.
-
Remove the power Output Stage - 1 - from headlamp housing.
-
Release the spring and disconnect the wires - 2 and 3 -.
-
Remove the power output stage.
Installing
‹› Tightening specification, refer to => [ LED Headlamp Assembly Overview ] See: Lighting and Horns/Headlamp/Service and Repair/Removal and
Replacement/LED Headlamp Assembly Overview.
Install in reverse order of removal, observing the following:
-
Check the seal - 4 - between the power output stage and headlamp housing for damage.
-
Install headlamp. Refer to => [ LED Headlamp Housing ] See: Lighting and Horns/Headlamp/Service and Repair/Removal and Replacement/LED
Headlamp Housing.