RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
![background image](/audi/rs_4_quattro_cabriolet/v8-4.2l_(bns)/Page-3325002.png)
‹› Removal:
-
Remove floor covering from luggage compartment.
-
Loosen two nuts - 2 - on rear cross panel trim - 1 - behind spare wheel and remove nuts.
-
Remove luggage compartment lighting connector.
-
Unclip rear cross panel trim - 1 - upward from four metal clips - 3 -.
‹› Installing:
To install, perform the steps used in removal in reverse order. Observe the following when doing so:
‹› after assembling trim, make sure seal is properly fitted.
‹› Reconnect lighting connector.
2
Nuts (Qty. 2)
‹› Tightening specification 5 Nm
3
Metal Clips (Qty. 4)