RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
![background image](/audi/rs_4_quattro_cabriolet/v8-4.2l_(bns)/Page-496001.png)
Alignment: Service and Repair
Toe Constant S, Adjusting
Toe Constant S, Adjusting
-
Loosen hex head nut - A -.
-
Remove the bolt - B - approximately 4 mm.
-
Push toe rod joint downwards onto stop.
‹› Do not use a chisel or similar tool between steering arm - 1 - sealing washer - 2 - when removing tie rod, otherwise sealing washer could be
damaged.
‹› Tie rod may only be pressed off steering arm over tie rod ball joint pin ends or driven with a wooden or rubber hammer.
-
Install bolt - B - until specified value is reached exactly.