RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Tighten hex head nut - A - and check value.
-
Tighten bolt - B -
-
Lower vehicle to initial position again.
-
Screw threaded spindle down.
-
Bounce suspension of vehicles with standard suspension several times.
Checking toe constant after adjusting
Wheel alignment equipment will check toe constant again.
If the measured values for the second check are within the check value tolerances then the adjustment is OK.
If measured values are not within control values, they must be set again in raised position.