RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
Removing
-
Remove bolts - arrows - and remove securing plate - 1 -.
-
Pull thin insulation hose or heat-shrinkable tube tightly over splines of input shaft.
-
Pull guide sleeve - 2 - over insulation hose out of transmission housing.
Installing
-
Replace the O-ring in the transmission housing => [ Replace O-rings ]
-
Fill volume between sealing lip and dust lip with Sealing Grease (G 052 128 A1).
-
Lightly lubricate outer circumference of guide sleeve.
-
Slide guide sleeve - 2 - over input shaft in transmission housing.
-
Remove insulating hose or heat-shrinkable hose.
-
Attach securing plate - 1 -.
-
Clean bolt threads - arrows - with a wire brush. Then insert bolts with Locking Compound (AMV 185 101 A1 ) and tighten to 24 Nm.
Replace O-rings
-
Pry off O-ring - arrow - with a small screwdriver.
-
Coat new O-ring with transmission oil before installing.