RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
-
Attach Alignment Fixture - 4W Dr. Shaft 3139 and tighten plastic nuts.
Note:
^
Never set alignment fixture on balance plates.
-
Remove mounting bolts - arrows - for intermediate bearing.
-
Loosen securing bolts of front driveshaft - arrows -.
-
Remove driveshaft from transmission and support it using engine/transmission jack V.A.G 1383 A.
-
Remove mounting bolts - arrows - on rear CV joint and remove driveshaft.
Note:
^
Only store and move driveshaft fully extended.