RS 4 Quattro Cabriolet V8-4.2L (BNS) (2008)
/Page-1512003.png)
^
Pressing on
^
Greasing
^
Adhesive surface must be free of oil and grease
^
When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.
4 - Backing plate
5 - Multi-point socket head bolt
^
Torque specifications:
Screw M 8: 40 Nm
Screw M10: 65 Nm
6 - Protective boot for inner CV joint with cap
^
With vent hole
^
Carefully drive off cap with drift
^
Always replace
^
In case of damage, check inner constant velocity joint
^
Coat sealing surface with D 454 300 A2 before installing on constant velocity joint
^
Align cover to screw holes
^
Protective boot/drive axle sealing surfaces must be free of grease at installation
7 - Axle shaft
8 - Outer constant velocity protective joint boot
^
Without ventilation bore
^
Check for tears and chafing; replace if necessary
^
In case of damage, check outer constant velocity joint
^
Protective boot/drive axle/joint sealing surfaces must be free of grease at installation
9 - Clamp
^
Always replace
^
Tensioning
10 - Circlip
^
Always replace
^
Insert in shaft groove
11 - Outer constant velocity joint
^
Exterior diameter: 88 mm
^
Replace only as a unit
^
Driving off
^
Installing: Drive onto shaft using plastic hammer until compressed circlip seats.
^
Circlip must lie in joint chamfer when guiding in, guide with pliers if necessary.
^
Greasing
^
When installing joint on profile shaft, profile shaft splines must be lightly coated with grease used in joint.
12 - Collar bolt
^
Always replace
