S4 V8-4.2L (BHF) (2004)
8 - Bearing shell
^
For guide frame without lubricating groove
^
Do not interchange used bearings (mark)
^
Insert new bearing shells for guide frame with proper color marking
9 - Crankshaft
^
Do not turn crankshaft when measuring radial play
10 - Thrust washer
^
Only at 4th crankshaft bearing
^
Lubricating grooves face outward
11 - Bearing shell
^
For cylinder block with oil groove
^
Do not interchange used bearings (mark)
^
Insert new bearing shells for cylinder block with proper color marking
12 - Gasket
^
Replace
13 - Cylinder block
^
Sealant applied on cylinder block (for guide frame)
Applying on sealant on cylinder block (for guide frame)
-
Clean sealing surfaces so they are completely free of oil or grease.
-
Apply sealant beads - arrows - on clean sealing surfaces of guide frame as shown in illustration.
^
Thickness of sealant beads: 1.5 to 2.0 mm
-
Install seals - 1 to 3 -.