S4 V8-4.2L (BHF) (2004)
-
Remove left locking ring using wrench 3087.
-
Carefully pull locking flange with Fuel Level Sensor 2 G169 and seal slightly out of fuel tank opening.
-
Remove fuel line - 1 - from fuel tank.
-
Pivot locking flange - 2 - with fuel level sensor 2 G169. Pos. 3. and suction jet pump - 4. out of fuel tank opening.
NOTE: When removing, be sure not to bend floater arm of fuel level sensor 2 G169.
-
Unclip suction jet pump from locking flange with Fuel Level Sensor 2 G169.
-
Press release buttons - arrows - and separate fuel hose at the Y-fitting.
-
Remove locking flange with fuel level sensor 2 G169.
Installing
Installation is in reverse order of removal. Note the following:
NOTE:
-
Replace seal.
-
When installing, be sure not to bend floater arm of fuel level sensor 2 G169.
-
Make sure fuel hose is seated securely.