S4 V8-4.2L (BHF) (2004)
-
Slide cover -8-at bottom over bracket - 7 -.
-
Turn back cover in area of side airbag - 2 -.
-
Unzip - 1 - protective cover of side airbag - 4 -.
-
Open securing clip at side airbag connector - 5 - and disconnect connector.
-
Turn back cover and upholstery in area of side airbag - 2 - far enough so the back side of the side airbag is accessible.
-
Remove nuts - 6 - (2x).
-
Remove side airbag - 2 -.
-
Installing:
-
Install side airbag - 2 - in reverse order of removal.
-
Fasten zip - 1 - at protective cover for side airbag - 4 -, using closing pliers VAS 6273.
-
Switch on ignition.
CAUTION: No one should be in vehicle when connecting battery.
-
Connect the battery ground (GND) strap.
NOTE:
-
Follow safety measures after connecting battery.
-
If the Airbag Malfunction Indicator Lamp (MIL) K75 shows a malfunction after assembly, DTC memory must be checked with Vehicle
Diagnostic, Testing and Information System VAS 5051 A , cleared and then rechecked.
3
-
Side retaining strips
4
-
Protective cover for side airbag
5
-
Connector for side airbag
6
-
Nuts (2x)
7
-
Support
8
-
Cover
9
-
Lower retaining strip