S4 V8-4.2L (BHF) (2004)
Output Shaft: Service and Repair
Flanged Shaft (Right Side), Removing and Installing
Flanged shaft (right side), removing and installing, 09L, 6 Spd. A/T AWD
Special tools, testers and auxiliary items required
Drip tray VAG 1306
Removing
^
Transmission installed
-
Unbolt heat shield - arrow - from transmission above drive axle (right-side).
-
Unbolt drive axle (right-side) from flange on transmission and tie up.
-
Place drip tray V.A.G 1306 under transmission.
-
Remove flange shaft: Place a chisel or suitable spacer - A - under flange shaft and pull flange shaft out by turning bolt - B -.
Note:
^
If the flange shaft does not come out easily, turn the shaft and screw the bolt into the opposite hole to assist removal.