S4 V8-4.2L (BHF) (2004)
-
Replace circlip for flange shaft
-
Clamp flange shaft in vise, using jaw protectors. Use new retaining ring - A - to press old retaining ring out of groove in flange shaft.
Installing
Installation is performed in reverse sequence. Note the following:
-
Clean flange shaft and seal.
-
If seal is damaged, it must be replaced.
-
Pack space between sealing lip and dust lip half full with sealing grease G 052 128 A1.
-
Insert flange shaft by hand into splines of differential until splines lock properly into place.
-
Press flange shaft in by hand or with mandrel VW 295 as far as stop.
Note:
^
The circlip on the flange shaft should click into place.
-
Bolt right drive axle to flange shaft.
-
Check oil level in front final drive.
Tightening Torque