S4 Quattro Sedan V6-2.7L Turbo (APB) (2000)
/Page-1266008.png)
-
Pull crankcase breather off cylinder head cover.
-
Remove cylinder head cover.
-
Remove double bearing cap -arrows
-
Take out oil seal and sealing flange.
-
Clean contact surfaces and sealing surfaces of double bearing cap.
-
Apply a thin coating of sealant, Part No. 454 300 A2, to shaded areas on double bearing cap (see illustration), fit bearing cap and tighten bolts to
10 Nm.
-
Fit guide sleeve (from tool set 3241) onto camshaft.
-
Press in oil seal until flush using press sleeve 3241/1 and bolt 3241/3.
-
Carefully knock in sealing flange against stop using 3202 and a plastic hammer.
Installing
Install in reverse sequence; note the points:
