S5 Quattro Coupe V8-4.2L (CAUA) (2009)
deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.
-
Disconnect the battery ground wire with the ignition switched on.
‹› If the airbag malfunction indicator lamp (MIL) (K75) indicates a fault after installation, check the DTC memory, erase it and check it again.
Front Passenger Airbag Disabled Indicator Lamp
Removing
‹› The front passenger airbag disabled indicator lamp (K145) is located in a shared housing with the emergency flasher button (E229) and cannot be
replaced separately if faulty.
-
Remove the MMI screen cover. Refer to => [ MMI Screen ] See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service
and Repair/Instrument Panel.
-
Press the passenger airbag indicator lamp - 1 - out of the installation frame - 2 - - arrow -.
Installing
Installation is reverse of removal, but note the following:
-
Press the front passenger airbag disabled indicator lamp (K145) into the installation frame until it engages audibly.