S5 Quattro Coupe V8-4.2L (CAUA) (2009)
Pressure Plate: Service and Repair
SAC Pressure Plate with Single Disc Clutch
SAC Pressure Plate with Single Disc Clutch
Special tools, testers and auxiliary items required
‹› Pressure plate (VW 402)
‹› Punch (VW 412)
‹› Thrust pad (VW 510)
‹› Alignment fixture (T10254/3)
‹› Thrust piece (T40089/2)
Removing
‹› The clutch module is removed => [ Clutch Module ] See: Service and Repair/Removal and Replacement/Clutch Module.
CAUTION!
The pressure plate and the dual mass flywheel could be damaged.
‹› Only remove and install the pressure plate - 1 - when it is pre-tensioned.
‹› Pressure plates that are not pre-tensioned will distort when loosening or tightening the bolts - 2 - and that leads to shuddering when
accelerating.
‹› The dual mass flywheel - 1 - must only be supported by the support ring - arrow A - when tensioning the pressure plate - 3 - in the hydraulic
press.
‹› If the dual mass flywheel is supported on the transfer plate - arrow B -, it will distort and be damaged. The dual mass flywheel must then
be replaced.