S6 V8-4.2L (BBD) (2004)
-
Disconnect harness connector -3- from Mass Air Flow (MAF) sensor.
-
Disengage EVAP canister valve -2- from air filter housing.
-
Disconnect hose -1- from Secondary Air Injection (AIR) pump (turn toward left and pull off).
-
Remove air guide hose from intake tube.
-
Disconnect front right vacuum hose from engine.
-
Remove bolt (arrow).
-
Remove air filter housing with Mass Air Flow (MAF) sensor and air guide hose.
-
Disconnect electrical harness connectors -1- and -3- for oxygen sensors and expose the wires.
NOTE: Secure a binding wire to connector for oxygen sensor behind catalytic converter to facilitate pulling in the wire during installation.
-
Loosen upper bolt on connection of exhaust manifold/exhaust pipe.
-
Loosen connecting bolts (arrows) at exhaust manifold/front exhaust pipe from below.