S6 V8-4.2L (BBD) (2004)
Instrument Cluster: Service and Repair
Adaptation After Replacing Instrument Cluster
Adaptation (function 10)
Using the adaptation function, the following changes can be made and saved.
-
Perform adaptation of vehicle keys
-
Adaptation after replacing instrument cluster.
-
Adaptation after replacing Engine Control Module (ECM).
-
Adaptation after replacing instrument cluster and Engine Control Module (ECM).
Adaptation after replacing instrument cluster
NOTE:
-
The instrument cluster (with integrated anti-theft immobilizer) is adapted to the Engine Control Module (ECM). If the instrument cluster is
replaced, the new instrument cluster must be re-adapted to the Engine Control Module (ECM).
-
After adapting the instrument cluster to the Engine Control Module (ECM), vehicle key adaptation must be performed.
-
If no authorized ignition key is available, but the secret number is available, new ignition keys must be made and adapted to "Adaptation after
replacing instrument cluster".
-
Adaptation can be interrupted using the "C" button.
Requirements
-
VAS5051 tester connected and vehicle On Board Diagnostic (OBD) selected.
-
ignition switched on.
Procedure
-
Insert old (authorized) ignition lock and switch ignition key into on ignition.
Display on VAS5051:
-
Press selection -1- of vehicle system "01 - Engine electronics".
-
Wait until the next indication appears on display.
Display on VAS5051: