S8 Quattro Sedan V8-4.2L (AYS) (2002)
-
Disconnect harness connector, press spring for this and disconnect connector.
-
Remove wire for brake pad wear indicator from bracket at brake caliper.
-
Carefully lift alignment tab slightly at lower part of connector using a screwdriver, then turn 90° toward left or right and remove from bracket.
-
Press floating frame powerfully in direction of arrow until stop.
-
Carefully press brake pads out of piston using a screwdriver and remove brake caliper housing.
Note:
Clean brake caliper housing thoroughly before installing new brake pads.
Be especially careful to remove any residual adhesive foil, left by outer brake pads.
Installing