S8 Quattro Sedan V8-4.2L (AYS) (2002)
Re-grease joint, if necessary, when replacing the joint protective boot.
1 - Circlip
^
Remove and install using commercially available circlip pliers
2 - Gasket
^
Replacing. Pull off protective foil and stick self-adhering side of gasket onto joint.
3 - Inner constant velocity joint
^
Outside diameter: 108 mm
^
Only replace complete
^
Pressing off, refer to Fig. 1
^
Pressing on, Refer to Fig. 2
4 - Protective boot for inner constant velocity joint
^
With vent hole
^
Check for tears and chafing
^
Drive off with drift
^
Before Installing on constant velocity joint, coat sealing surface with D 454 300 A2 housing sealant
5 - Profiled shaft
^
Same length on left and right
6 - Protective boot
^
Check for tears and chafing
7 - Hose clamp
^
Always replace
^
Tightening, Refer to Fig. 3
8 - Dished washer
^
Installation position, Refer to Fig. 5
9 - Spacer ring (plastic)
^
Installation position, Refer to Fig. 5
10 - Circlip
^
Always replace
^
Insert in shaft groove
11 - Outer constant velocity joint
^
Outside diameter: 98 mm
^
Only replace complete
^
Removing, Refer to Fig. 4
^
Installing:
-
Drive onto shaft with plastic hammer until circlip engages