TT Quattro Coupe L4-1.8L Turbo (BEA) (2003)
/Page-2891001.png)
Brake Caliper: Service and Repair
Rear Brake Caliper - AWD, Remove/Install
Brake caliper - vehicles with all wheel drive, removing and installing
Special tools and equipment
^
Brake pedal depressor VAG 1 869/2
Removing
^
Remove brake pads.
^
Insert brake pedal depressor VAG 1869/2 between brake pedal and driver's seat. Depress the brake pedal by at least 60 mm.
Note: Pressing down the brake pedal closes the valves in the brake master cylinder to prevent the brake fluid reservoir from running dry.
^
Connect bleeder bottle hose to bleeder screw of removed brake caliper.
^
Open bleeder screw.
^
Do not remove brake pedal depressor VAG 18169/2.
^
Unscrew brake hose from brake caliper.
Installing
Install in reverse sequence; note the following points:
^
Install brake pads.
^
After servicing or replacing, new brake caliper, parking brake cable must be adjusted. Adjust parking brake . Do not press foot brake until parking
brake has been adjusted.
^
Bleed brake system: ABS/ESP Mark.
Tightening torque
