TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
Air Bag: Service and Repair
Driver Knee Airbag
Driver Knee Airbag
Removing
-
Move driver's seat all the way back and put backrest at a 45° angle.
CAUTION!
‹› Observe safety precautions for work on airbags. Refer to => [ Airbag System General Safety Precautions ] See: Service Precautions.
-
Switch off ignition.
-
Clamp off ground wire at battery with ignition switched off.
-
Remove knee bar (driver side instrument panel cover) => [ Driver Side Instrument Panel Cover ].
-
Unclip 16-Pin Connector (T16) (for the Data Link Connector).
-
Remove bolts - A - (below knee airbag - 1 -) and - B - (above knee airbag).
-
Then remove driver side footwell air channel - 2 - from passenger side footwell air channel - 3 -.
CAUTION!
‹› Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "discharge static electricity". This
can be done by touching door striker, for example.
-
Disconnect knee airbag connector (yellow).