TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› If, by cutting out the damaged wire section, both ends of the vehicle-specific single wire are too short for a repair using a single crimp connector,
insert a repair wire section of matching length with two crimp connections => [ Wire, 0.25 mm with Intermediate Wire Section, Repairing ].
-
Adjust the sliding stop in the Wire Stripper ( VAS 1978/3) pliers jaws to 12 to 14 mm for the wire to be stripped.
-
Insert wire end from front up to stop into jaws of pliers and squeeze the pliers completely.
-
Open pliers again and remove the stripped wire end.
-
Twist bare strands one-half turn.
-
For the repair of a 0.25 mm 2 wire, use a small yellow crimp connector from the Wiring Harness Repair Set (VAS 1978A ).
-
To press the crimp connector, use the Crimping Pliers (Base Tool) (VAS 1978/1-2) with Exchangeable Head, 0.35-2.5mm² (VAS
1978/1-1).