TTS Quattro Roadster L4-2.0L Turbo (CDMA) (2009)
‹› Previous shim - 2 - for shaft beveled gear preload - 1 - must be installed.
-
Install taper roller bearing inner race - 3 - into the outer ring in the bevel box.
-
Lightly apply oil to the outer diameter of the new seal - 4 - for the output flange.
-
Drive in shaft seal as far as stop with thrust piece (T10049).
-
Fill space between the sealing and dust lip half way with sealing grease.
-
Pull the output flange in; when doing this mount the pulling hooks - A - at the bottom of the drive pinion housing.