V8 Quattro V8-3562cc 3.6L DOHC (PT) (1990)
Caution
Up to VIN N 001 461 it is not possible to replace the bonded rubber bushings. Install a complete support when repairing.
Note:
The component parts illustrated are from a left rear location on the vehicle.
1 - Mounting stud
2 - 170 N-m (125 ft.lb.)
^
always replace
^
clean out threads of control arm with M14 x 1.5 tap
^
tighten only with vehicle standing on wheels
3 - Washer curved version see Note.
Note:
Only curved version washers are installed from VIN N 00 1 462. When installing new supports, Part Nos. 4A0 511 329A1330A, in vehicles prior to VIN
N 00 1 462, always install curved version washers in place of previously installed 3 mm and 6 mm washers.
4 - Front bushing
^
do not interchange with rear bushing
^
replacing, in this bulletin
5 - 135 N-m (100 ft.lb.)
^
always replace
6 - Support
^
identify left and right part before pressing in bushings
^
replacement available with bushings installed
^
install on vehicle so that mounting studs are centered in holes
^
check rear toe after installing
7 - Rear bushing
^
do not interchange with front bushing
^
replacing, in this bulletin
8 - Washer
^
curved version
^
see Note in item 3
9 - Trapezoidal control arm
Bonded rubber bushing in control arm support (three-point mounting), replacing
-
insert internal extractor tool into bushing so that claws of extractor are located between two halves of bushing
^
use Kukko No. 21/2 or equivalent commercially available puller
-
tighten nut -a-