1 Series E81 130i (N52K) 3-door
Note:
The required parts are available from the BMW Parts Service
(ETK).
Remove screw caps (1) from injector (2).
Screw on metering needle.
Insert piston for pressing out.
Injector (2) contains the sealing compound Loctite,
manufacturer's number 128357.
Bottle (3) contains the primer Loctite, manufacturer's
number 171000.
Installation:
Fit support bushing (4) with crankshaft radial seal (1) on
crankshaft.
Align groove (2) centrally to housing partition (3).
Coat both grooves (2) on crankshaft radial seal (1) with Loctite
primer, manufacturer's number 171000, and expose to air for
approx. one minute.
Push crankshaft radial seal (1) by hand as far as possible onto
running surface.
Carefully remove support sleeve (4).
Note:
Spacer ring (1) is supplied with radial shaft seal.
Screw special tool 11 9 182 with screws (special tool
11 9 184 ) to crankshaft.
Fit spacer ring (1) on preassembled radial shaft seal.
Draw in radial shaft seal and spacer ring with special tool
11 9 181 in conjunction with special tool 11 9 183 .
Then remove spacer ring again.
RA Replacing crankshaft radial seal (transmission side) (N52K)
BMW AG - TIS
22.01.2013 03:21
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -
