1 Series E81 130i (N52K) 3-door
13 62 010
Removing and installing/replacing differential
pressure sensor (N52 / N52K / N51)
Necessary preliminary tasks:
•
E90 / E91 / E92 / E93 / E87:
Remove lower section of microfilter housing
•
E85 / E86 E90 / E91 / E92 / E93:
Remove left tension strut on suspension strut dome
•
E70:
Remove intake filter housing
Important!
Read and comply with notes on protection against
electrostatic damage (ESD protection).
Release screws.
Unlock plug (1) and remove.
Pull differential pressure sensor (2) out of intake air manifold.
Installation:
Read out fault memory of control unit of Digital Engine Electronics
(DME).
Check stored fault messages.
Now clear the fault memory.
RA Removing and installing/replacing differential pressure sensor (N52 / N52K / N51
BMW AG - TIS
22.01.2013 03:50
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
