Removing and Installing Power Window Unit
51 33 000
Removing and installing (replacing) power
window unit in left or right front door
Warning!
Risk of injury!
Carry out work on the power window unit only when the power
window motor is de-energized.
Necessary preliminary tasks:
•
Remove front door window glass
Peel back film (1) and loosen nuts below.
Release nuts (2) and feed out rear section of power window
unit (3).
Tightening torque 51 33 1AZ
.
Installation:
Replace defective film (1) if necessary.
Loosen window regulator (3) at bracket (1).
Release nuts (2) and completely feed out power window unit (3).
Replacement:
Remove flat motor for power window unit.
RA Removing and installing (replacing) power window unit in left or right front doo
BMW AG - TIS
22.01.2013 07:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -