1 Series E87 118d (M47T2) 5-door
32 41 060
Removing and installing/replacing power
steering vane pump (M47T2)
Warning!
Danger of poisoning if oil is ingested/absorbed through the
skin!
Risk of injury if oil comes into contact with eyes and skin!
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Close off pipe connections with plugs.
Recycling:
Catch and dispose of hydraulic fluid in a suitable container.
Observe country-specific waste-disposal regulations
Necessary preliminary tasks:
•
Draw off and dispose of hydraulic fluid from fluid reservoir
•
Remove belt pulley
Release hose clamp (1) and detach suction line (2) from vane
pump.
Installation:
Markings on suction line and vane pump connection must match
up.
Release banjo bolt (3) and disconnect pressure line (4).
Installation:
Replace all sealing rings (D).
RA Removing and installing/replacing power steering vane pump (M47T2)
BMW AG - TIS
18.01.2013 10:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -