1 Series 125i (N52K) Convertible
Important!
When pressing down piston, note brake fluid level in
expansion tank.
Overflowing brake fluid will damage the paintwork.
Turn piston fully back with special tool 34 1 050 .
Check minimum brake disc thickness:
-
Position special tool 34 1 280 at three measuring points in
area (1) and measure.
-
Compare measurement result and lowest value with setpoint
value.
New brake pads may only be installed if the brake disc thickness
is greater than or equal to the minimum brake disc thickness (MIN
TH).
Check dust sleeve (1) for damage and replace if necessary.
Important!
Dust sleeve must not come into contact with anti-squeak
compound as this may cause the dust sleeve to swell.
Clean contact face (2) of brake piston and apply a thin coating of
anti-squeak compound.
Clean contact faces (1) of brake pad hammer heads/brake caliper
housing and coat with anti-squeak compound.
RA Removing and installing or replacing brake pads on both rear disc brakes (Teves
BMW AG - TIS
17.01.2013 10:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -