1 Series 125i (N52K) Convertible
Clean contact face (1) of brake caliper and apply a thin coating
of anti-squeak compound.
Clean brake caliper holder at hammerhead guides (1) and apply a
thin coating of anti-squeak compound.
Note:
After completing work:
-
Fully depress brake pedal several times so that brake
pads contact brake discs.
-
When installing new brake pads at front and rear axles,
brake fluid level must be brought up to "MAX" marking.
-
Read and comply with notes on braking in new brake
discs / brake pads.
-
When replacing pads, reset CBS display in accordance
with factory specification.
RA Removing and installing or replacing brake pads on both rear disc brakes (Teves
BMW AG - TIS
17.01.2013 10:08
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -