3 Series E36 316i (M43) SAL
Installation:
Diaphragm spring (2) with inside curved surface facing
differential shaft (up).
Insert thrust washer (3) with oil pockets facing up to
differential shaft.
Installation:
Insert diaphragm spring (4) with inside curved surface facing
differential shaft and outer plate (5) with four tabs. Insert
moybdenum coated inner plate (6) and thrust ring (7).
Installation:
Install differential side gear (8) by turning into guides or
splines of inner plate.
Install differential gears with shafts (9) and a second differential
side gear (8).
Installation:
Install thrust ring (7), molybdenum coated inner plate (6) and
outer plate (5).
Insert diaphragm spring (4) with inside curved surface facing
differential shaft (down).
RA Dismantling and assembling limited slip differential (Type K) - final drive remo
BMW AG - TIS
20.01.2013 06:16
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -