3 Series E36 316i (M43) SAL
86 21 ...
Adjusting rear lid to fit
Note:
The following text describes how to adjust the rear lid to fit at
one mounting point as an example. Proceed in the same way
for the other mounting points.
Height adjustment of rear lid:
Release screws (1) and move rear lid in direction of arrows.
Depth adjustment of rear lid:
Release screws (2) and move rear lid in direction of arrows.
Installation:
Tightening Torque, height adjustment,
refer to Technical Data 86 21 7AZ.
Tightening Torque, depth adjustment,
refer to Technical Data 86 21 9AZ.
Adjust gap (A) evenly all around without displacement and
correct if necessary.
Check lid in transition (B) to hood for displacement and correct if
necessary (flush).
RA Adjusting rear lid to fit
BMW AG - TIS
20.01.2013 10:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -