3 Series E36 316i (M43) SAL
To align lid in transverse direction, you can install or remove
plastic washers (3) between hinge bracket (1) and mounting
bracket (2).
Installation:
There must always be a plastic washer (3) fitted on left and
right sides of mounting bracket (2). Plastic washers are
available in thicknesses of 1 mm and 3 mm.
Check lid in transition (C) to hood (flush) and correct if
necessary. Correction is made by inserting or omitting plastic
washers (refer to Fig. R86 0201).
RA Adjusting rear lid to fit
BMW AG - TIS
20.01.2013 10:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -