3 Series E36 318i (M44) SAL
11 28 020
Replace the tensioning device for the drive
belt of the generator (M44)
Removing alternator drive belt,
refer to 11 28 010
Remove the belt wheel of the vane pump.
Caution!
The bolt connection (1) of the pulley for the tensioning device
for the drive belt has left-hand thread and is peened.
Only change the pulley in conjunction with the tensioning
device for the drive belt.
Loosen screws (1).
Loosen the screws (2) and remove with the tensioning device for
the drive belt.
Note:
If the screw (2) is inaccessable because of the lug (3), lock
the tensioning device for the drive belt using Special
Tool 11 3 340.
If necessary, apply preload to the tensioning device for the drive
belt on the pulley as far as possible and lock with Special
Tool 11 3 340.
Caution!
The tensioning device for the drive belt is under high spring
pressure.
Press Special Tool 11 3 340 in as far as possible.
RA Replace the tensioning device for the drive belt of the generator (M44)
BMW AG - TIS
27.01.2013 02:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
