3 Series E36 318i (M44) SAL
11 31 505
Adjusting timing of camshaft(s) (M44)
(re Oper. No. 11 31 005)
Note:
Before performing the adjustment work, check timing of
camshaft,
refer to 11 31 005
Remove Special Tool 11 3 240 from cylinder head.
Remove Special Tool 11 2 300 from locating bore in engine
block.
Rotate the engine on the central bolt enginewise until the
camshafts on the fourth cylinder are located in the firing TDC
position.
Loosen two screws on each chain wheel.
Rotate the engine on the central bolt enginewise until the
camshafts on the fourth cylinder are located in the firing TDC
position.
RA Adjusting timing of camshaft(s) (M44)
BMW AG - TIS
27.01.2013 02:47
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
