3 Series E36 M3 (S52) COUPE
Drive new shaft seal firmly home with special tool 00 0 500 and 33
3 440 (Type G) or 33 3 470 (Type M) or 33 3 430 (Type K).
Coat sealing lips of shaft seal and sealing face of new input flange
with final drive oil,
refer to BMW Service Operating Fluids.
Fit new input flange pressing down if necessary with special tool
33 1 341 and 23 1 300 (Type K) as well as 23 1 302 (Type M / G)
until it is possible to fit the nut.
Brace input flange with special tool 23 0 020 and tighten down nut
to tightening torque,
refer to Technical Data 33 12 2AZ
Measure friction torque.
If the friction torque determined prior to assembly, plus 20 Ncm for
the new shaft seal has not yet been reached, continue tightening
down the nut until this level of friction torque is reached.
Example:
Friction torque prior to disassembly 160 Ncm
New shaft seal + 20 Ncm
Adjust friction torque to 180 Ncm
RA Replacing shaft seal and input flange on final drive (Type K / M / G)
BMW AG - TIS
10.02.2013 05:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -