3 Series E36 M3 (S52) SAL
3. Bleed hydraulic unit ABS/ASC+T
Connect BMW Service Tester to vehicle diagnosis connector.
Select number 50 "Teves Slip Control System" from control-unit
overview, followed by number 5 "Special Functions" from the
menu and finally number 1 "Bleeding Routine for ASC+T".
4. Bleed braking system
Connect bleeder hose with bottle to rear-right brake caliper.
Open bleeder valve and flush braking system while operating
brake pedal as far as it will go at least 10 times (escaping brake
fluid must be free of air bubbles).
Keep brake pedal pressed down, close bleeder valve and release
brake pedal.
Bleed brakes in the same manner at left rear, right front and left
front.
Installation:
Use dust caps on bleeder valves.
5. Bleed accumulator ASC+T (only vehicles up to 09.93)
Remove liner from inside of front-left wheel house.
RA Bleeding brake system with ABS/ASC+T
BMW AG - TIS
10.02.2013 09:53
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -