3 Series E36 M3 (S52) SAL
86 21 ...
Installing seal for rear lid and side lid
Note:
The following text describes how to install the seal for the rear
lid as an example. Proceed in the same way for the side lids.
Removing old seal:
Open lid. Grip seal piping with both hands and pull seal off
hood ridge. Remove old seal over lid.
Push seal piping (1) by hand onto hood ridge (2). Using a rubber
hammer, gently tap seal piping (1) as far as it will go onto hood
ridge (2). Make sure piping (1) is evenly positioned especially in
radii of hood ridge.
Installation:
Always position end face of seal in a straight area only:
e.g. on cross-member or on upper hood ridge of rear lid.
Suitable areas on side lids:
Upper and lower hood ridge.
Sealing lip of seal must point outwards.
After installing from inside and outside, check correct seating
between lid seal and lid. Lid must rest without air on lid seal.
RA Installing seal for rear lid and side lid
BMW AG - TIS
10.02.2013 18:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -