3 Series E36 M3 (S52) SAL
86 21 ...
Installing sponge rubber seal
Note:
Removing old sponge rubber seal: Pull off old sponge
rubber seal. Remove remaining traces of adhesive with
universal cleaner, refer to BMW Operating Fluids.
Sponge rubber seal runs along area marked gray (1).
Lay sponge rubber seal (1) in middle of hood contact
surface (2).
Installation:
Degrease contact surface (2) with benzine and rub down
with a dry cloth. Stick on sponge rubber seal (1) according to
manufacturer's instructions. Position end face of seal (1) in a
straight area.
RA Installing sponge rubber seal
BMW AG - TIS
10.02.2013 18:51
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -