3 Series E46 316i (M43TU) SAL
11 12 100
Removing and installing/sealing cylinder head
(M43TU)
Remove intake filter housing with air-mass flow sensor,
refer to 13 71 000.
Remove ignition coils,
refer to 12 13 512.
Remove all spark plugs,
refer to 12 12 011.
Remove exhaust pipe from exhaust manifold,
refer to 18 00 020.
Remove timing case cover at top,
refer to 11 14 100.
Remove manifold lower section,
refer to 11 61 044.
Drain coolant from engine block.
Installation:
Replace sealing ring.
Tightening Torque,
refer to Technical Data 11 11 5AZ.
Detach water hoses from cylinder head.
Removal
Removal of cylinder head is described separately from installation.
Assembly sequence for removal and installation is different.
RA Removing and installing/sealing cylinder head (M43TU)
BMW AG - TIS
19.01.2013 10:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
