3 Series E46 316i (M43TU) SAL
Checking nozzle setting:
Attach special tool 11 7 320 to the intake side in the receiving
bore hole in the engine block.
The spray nozzles must fit into the guide of special
tool 11 7 320.
If necessary, loosen the spray nozzles and adjust and tighten
them using special tool 11 7 320.
Tightening Torque,
refer to Technical Data 11 11 7AZ.
Note:
When crankshaft or main bearing shells are being replaced,
the classification for the arrangement of the main bearing
shells in the crankcase is no longer of significance. Install
yellow main bearing shells in crankcase.
Note:
Guide bearing shell installed at bearing No. 4 is sole means
of axial alignment for crankshaft.
Insert pilot bearing shell in the engine block.
Install crankshaft.
Note:
The crankshaft is marked with yellow, green or white paint
according to the tolerance of the main journal.
RA Replacing all main crankshaft bearing shells (M43 / M43TU)
BMW AG - TIS
19.01.2013 10:37
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
