3 Series E46 316i (M43TU) SAL
12 14 521
Replacing pulse generator on crankshaft
(M43TU)
Turn off ignition.
If installed:
Remove underbody protection (1 and 2).
The installation location for the pulse generator is below the
starter.
Disconnect plug connection (1).
Release screw (1).
Remove pulse generator.
Installation:
Check sealing ring and replace if necessary.
Installation:
Read out fault memory of DME control module, check stored
fault messages, rectify faults, cancel fault memory.
RA Replacing pulse generator on crankshaft (M43TU)
BMW AG - TIS
19.01.2013 10:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
